CAT50 16mm x 100mm Shrink Fit Holder With Coolant Ports

Specifications

Shank Type

Taper Shank

Taper Size

CAT50

Hole Diameter (mm)

16

Projection (mm)

160

Nose Diameter (mm)

27

Through Coolant

Yes

Unsurpassed Accuracy

Concentricity of ≤0.0001" (3µm) with tool shrunk in holder. • Coolant Ports: Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool. • Max Gripping Torque: Tool is gripped 360º along the entire length of bore producing very high gripping torque, preventing chatter. • Increased Production: Decrease down time - the total time elapsed to remove one cutting tool and insert another is less than 10 seconds. • Balanced: GS follows the strictest balance standards. Our holders are pre-balanced G2.5 up to 30,000rpm • Extended Holder Life: With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder. • Chip load distributed evenly along cutting edge of tool which results in longer tool life • Short projections are possible because no mechanical clamping devices are used. This results in greater rigidity and resistance to bending. • Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market